70
Maintenance
Service Manual
Step
Procedure
11.Remove swing motor
10.Remove xed support
12.Remove guide loop (upper), case, swing
blade, guide louver, crankshaft 1 and axle
sleeve
Fixed mount
(swing motor)
Screws
swing motor
guide loop (upper)
crankshaft 1
clasps
guide louver
axle sleeve
swing blade
case
Screws
Screws
Crankshaft 2
Connecting Rod
Take out the crankshaft 2 and connection rod
at first and then remove one screw used for
xing the xed mount (swing motor), and then
take out the xed mount.
Remove 2 screws used for fixing the swing
motor and then take it out.
Remove 3 screws used for fixing the guide
loop(upper) and then the motor block, loose 3
clasps and then remove the guide loop (upper),
case, swing blade, guide louver, crankshaft 1
and axle sleeve.
To Next Page
Loading...
