73
Maintenance
Service Manual
Step
Procedure
19.
20 .
21.
Remove case out
Remove loop(lower)
Remove centrifugal blade
Remove one screw used for xing the case
and then take the case out.
Remove 3 screws on the guide loop (lower),
loose 6 clasps and then take out the guide
loop(lower).
Take out the nut, remove washer 6 and
washer 6 (at washer), and then remove the
centrifugal blade.
Screws
Screws
Clasps
Guide loop(lower)
Case out
Clasps
washer 6 (at washer)
washer 6
nut
centrifugal blade
To Next Page
Loading...
