72
Maintenance
Service Manual
Step Procedure
16.
17.
18.
Remove Wire Clamp
Remove Air duct sub-assy 2
Remove Detection Board
Remove 1 screw on the wire-xing
clamp and then take out the wire-
xing clamp and then power cord.
Wire Clamp
Screws
Screws
Screws
Screws
Water retaining box
Air duct sub-assy 2
Display board
Detection board
Remove 5 screws used for xing
the air duct sub-assy and then take
out the air duct sub-assy 2.
Remove the water retaining box
and the display board, and then
remove the screws used for xing
the detection board, and then
remove the detection board.
To Next Page
Loading...
