GREE U-Match 5 SERIES UNIT SERVICE MANUAL
110
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
6. Connect the compressor
suction port and exhause port
with the pipes.
Weld the compressor
connection pipes and
connect them to the
compressor.
Note: When replacing the
compressor, avoid touching
the nearby pipeline and
components.
7. Connect the compressor
wires.
Connect the compressor
wires to the wire terminals
on the top of compressor.
Note: When connecting the
wires, be sure to match the
colors with the
corresponding wire
terminals.
Model: GUD35W/NhA-T, GUD50W/NhA-T, GUD71W/NhA-T, GUD85W/NhA-T
Removal of 4-way valve
Note: Before removing the 4-way valve, make sure refrigerant is fully discharged from the unit and power is cut off.
Step Picture Work instruction
1. Take off the electromagnetic
coil of the 4-way valve.
Carefully unscrew the
screws of electromagnetic
coil with a screwdriver.
To Next Page
Loading...
