GREE U-Match 5 SERIES UNIT SERVICE MANUAL
112
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step Picture Work instruction
2. Remove the fan.
Use a wrench to remove the
specialized nut and gasket of
the fan.
Note: Please keep the nut
and gasket safe after
removing them from the fan.
3. Remove motor.
Use a screwdriver to unscrew
the bolt of motor.
Note: Motor wire should be
first removed from the
electric box.
4. Install the motor.
Replace with a new motor.
Then tighten up the screw
bolt.
5. Install the fan.
Install the fan in place. Put on
the gasket and use a wrench
to secure the screw nut.
Note: After installing the fan,
turn the fan by hand to see if
it can run normally. If not,
please check for the reason.
6. Install the grill.
After replacing the motor, use
a screwdriver to tighten up
the screw bolt that secures
the motor.
To Next Page
Loading...
