Air Handlers
14
3) Remove the upper access panel from air handler.
4) Remove cover plate from air handler.
5) Slide the heater kit in to the slot and secure element plate with previously
removed screws.
6) Insert power leads into the circuit breaker lugs or stripped red and black
wires (for heater kit without circuit breaker) and tighten.
7) Connect ground wire to ground lug.
8) Break out appropriate area of the plastic circuit breaker cover on the access
panel of the air handler.
9) Replace access panel and check operation.
10) Connection of power cords and temperature controller cords.
To Next Page
Loading...