GREE U-Match 5 SERIES UNIT SERVICE MANUAL
97
Note: Before removing the fan, make sure power is cut off.
●Use a screwdriver to unscrew the
bolt of motor.
Note: Motor wire should be first
removed from the electric box.
●Replace with a new motor. Then
tighten up the screw bolt.
●Install the fan in place. Put on the
gasket and use a wrench to secure
the screw nut.
Note: After installing the fan, turn
the fan by hand to see if it can run
normally. If not, please check for the
reason.
●After replacing the motor, use a
screwdriver to tighten up the screw
bolt that secures the motor. Arrange
the wires according to the wiring
diagram.
To Next Page
Loading...
