Gree GUD71T/A-T

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
109
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step
Picture
Work instruction
3. Remove motor.
●Use a screwdriver to unscrew
the bolt of motor.
Note: Motor wire should be first
removed from the electric box.
4. Install the motor.
●Replace with a new motor. Then
tighten up the screw bolt.
5. Install the fan.
●Install the fan in place. Put on
the gasket and use a wrench to
secure the screw nut.
Note: After installing the fan, turn
the fan by hand to see if it can
run normally. If not, please check
for the reason.
6. Install the grill.
●After replacing the motor, use a
screwdriver to tighten up the
screw bolt that secures the
motor.