GREE U-Match 5 SERIES UNIT SERVICE MANUAL
121
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long
time, please put the copper pipe under pressure.
3. Remove the
evaporator.
●Take off the evaporator.
The removed evaporator
is as shown in the
picture.
4.5.2.3 Floor Ceiling Unit
Take model GUD160ZD/A-T as an example.
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the
components. Do not place the filter near any heat source.
Remove the
sub-assembly of front
grill.
●Twist off the 2 hooks
of the grill and the
screws of the hooks.
●Open the grill and
remove 2 lower
clamps. Then remove
th
e grill.
Remove the right and left decorative boards
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the
components. Do not scratch the appearance components.
Remove the left and
right panels.
●Use a screwdriver to
loosen the screws, as
shown in the picture.
Then pull the right
and left panels
upward. (Lines in the
picture indicate the
positions of screws.)