GREE U-Match 5 SERIES UNIT SERVICE MANUAL
120
Removal of compressor/gas liquid separator
Note: Before removing the compressor/gas liquid separator, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
2. Break off the pipes that
connecting to the
compressor/gas liquid
separator.
Weld the pipes that are
connected to the
compressor/gas liquid
separator.
Then remove the pipes.
Note: When welding the
pipes, do not let the flame
burn the other components.
3. Loosen the compressor’s
base connectors / gas liquid
separator’s base nuts.
Use a wrench to twist off the
compressor/gas liquid
separator’s base nuts.
4. Remove the compressor/gas
liquid separator from the
chassis.
Take away the
compressor/gas liquid
separator and replace with a
new one.
Note: When replacing the
compressor/gas liquid
separator, avoid touching the
nearby pipeline and
components.
5. Install the new
compressor/gas liquid
separator onto the chassis.
After replacing the
compressor/gas liquid
separator, tighten up the
base screw nuts.
To Next Page
Loading...
