GREE U-Match 5 SERIES UNIT SERVICE MANUAL
82
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
2. Loosen the securing screws at
the foot of compressor.
●Use a wrench to twist off the
screws at the foot of compressor.
3． Break off the pipes that
connecting to the compressor.
●Weld the pipes that are
connected to the compressor.
●Then remove the pipes.
Note: When welding the pipes, do
not let the flame burn the other
components.
4. Remove the compressor from
the chassis.
●Take out the compressor and
replace it.
Note: When replacing the
compressor, avoid touching the
nearby pipeline and components.
5． Fix the new compressor back
onto the chassis.
●After replacing the compressor,
tighten up the screws at the foot
of compressor.
To Next Page
Loading...
