U-Match Series DC Inverter Service Manual
126
Assemble the unit in the reverse procedures of
disassembly.
Remark: Before disassembly and assembly, make sure that the unit has been cut off from the power supply.
1. Remove external
casing
1. Remove the top cover and handle;
2. Remove the grille, outer case and right side
plate.
1. Remove the blade nut and then remove the
blade;
2. Remove the motor from motor support.
3. Remove gas liquid
separator
1. Discharge the refrigerant inside the pipeline and
recycle the refrigerant during discharging;
2. Unsolder the 4-way valve assy from gas liquid
separator;
3. Remove the gas liquid separator.
To Next Page
Loading...
