71
Installation and Maintenance
Service Manual
Step Procedure
Twist off 3 screws used for xing the
electric box cover and then remove
the electric box cover; pull the wiring
terminals of each elements and then
you can disassembly related electrical
parts according to your requirement.
Remove 9 screws used for xing the
electric box, pull it outwards and then
remove the complete electric box;
Remove 3 screws used for xing
the wire-passing groove cover and
then remove the wire-passing groove
cover.
Remove 3 screws used for xing
the wire-passing groove, and then
remove the wire-passing groove sub-
assembly.
4. Remove electric box and wire-passing groove
Electric box
Wire-passing
groove cover
Wire-passing
groove
Screw
Screw
Electric box cover
Hold the holding position at the upper
part of the filter and then draw it
outwards to remove the lter.
Remove 2 screws at the top of the air-
in panel, pull the middle air-in panel
upwards with hand and then remove
the middle air-in panel.
3. Remove lter and middle air-in panel
Holding position
Filter
Middle air-in panel
b
a
To Next Page
Loading...
