79
Installation and Maintenance
Service Manual
Step Procedure
7. Remove the left side plate
Remove the screws connecting the left
side plate and the chassis. Remove the
left side plate.
8. Remove axial ow blade
Remove the nut on the axial ow blade.
Remove the blade.
9. Remove the motor support and motor
Remove the tapping screws xing the
motor support. Raise the motor support
to remove it.
Remove the tapping screws xing the
motor. Disconnect the leading wire
insert of the motor. Remove the motor.
left side plate
axial ow blade
nut
motor support
motor
To Next Page
Loading...
