105
Installation and Maintenance
Service Manual
Steps
Twist off the screws connecting accumulator
and gas-liquid separator, and then remove
the accumulator and gas-liquid separator.
11.Remove accumulator and gas-liquid separator
gas-liquid
separator
accumulator
Procedure
Twist off the screws connecting supporting board
sub-assy(accumulator) and then remove the
supporting board sub-assy(accumulator).
12.Remove supporting board sub-assy(accumulator)
supporting board
sub-assy(accumulator)
13.Remove left side plate
left side plate
Twist off the screws connecting the left side plate
and chassis with screwdriver, and then remove
the left side plate.
To Next Page
Loading...
