29
Technical Information
Service Manual
6. Function and Control
● If the current power is lower than the maximum power of
mode, then the power will not be limited after entering into such
mode.
● For the model with one outdoor unit and two indoor units, if any
one of indoor units enters into power limiting function, the outdoor
unit will enter into the set limiting power mode of indoor unit;
when two indoor units enter into power limiting mode, then the
power of outdoor unit will be limited according to the lower power
of the two indoor units.
Note:
● This function is only available for some models.
Replacement of batteries in remote controller
1. Lift the cover along the direction of arrow (as shown in Fig 1
①
).
2.Take out the original batteries (as shown in Fig 1
②
).
3.Place two 7# (AAA 1.5V) dry batteries, and make sure the
position of “ + ” polar and “ - ” polar is correct (as shown in Fig 2
③
).
4.Reinstall the cover (as shown in Fig 2
④
).
Fig.1
①
②
④
NOTICE:
● During operation, point the remote control signal sender at
the receiving window on indoor unit.
The distance between signal sender and receiving window
should be no more than 8m, and there should be no
obstacles between them.
● Signal may be interfered easily in the room where there is
fluorescent lamp or wireless telephone; remote controller
should be close to indoor unit during operation.
● Replace new batteries of the same model when
replacement is required.
● When you don’t use remote controller for a long time,
please take out the batteries.
● If the display on remote controller is fuzzy or there’s no
display, please replace batteries.
function
Press "MODE" and "SLEEP" buttons simultaneously to start
function.
function is for limiting power of the whole unit. Press this button,
the remote controller will circu-larly display as the following:
blank
No Setting
● Maximum power limited under the mode is lower than that of
mode.
● If you want to cancel the power limiting function, press the
button till the icon in remote controller is not displayed.
● When the remote controller is turned off, power limiting function
is cancelled. If you want to activatethe function, please repress
this button.
To Previous Page
Loading...
