To Next PageTo Next PageWhy is there a thin fog or vapor coming out of my Gree GWH09AB-D3DNA2D?
It is normal for the Gree Air Conditioning system to emit a slight fog or water vapor when cooling extremely humid warm air. The fog or water vapor will disappear as the system cools and dehumidifies the room space.
What to do if my Gree Air Conditioner unit will not run?
Check the following: * Ensure the circuit breaker is not tripped or turned off. * Verify the power button on the remote is turned on. * Replace the batteries in the remote control if they are low. * Make sure the remote control is not in Sleep mode or Timer mode. If the issue persists, it's recommended to contact a qualified service professional.
What to do if Gree GWH09AB-D3DNA2D indoor unit is leaking water into the room?
If water is leaking from the indoor unit of your Gree Air Conditioner into the room: * Ensure the indoor unit is level from right to left; adjust if necessary. * Check the condensate drain tube for any restrictions or blockages and remove them to allow continuous drainage. If the problem persists, contact a qualified service professional for assistance.
Why is my Gree Air Conditioner leaking water outside?
If you observe water leakage in the outdoor unit of your Gree Air Conditioner, it's normal for the unit to generate condensate water in reverse cycle heating mode and during defrost. No action is required.
What to do if Gree GWH09AB-D3DNA2D remote is lost or not working?
If your Gree Air Conditioner's wireless remote controller is lost or not working, first check the batteries and replace them if they are low. Ensure that the remote controller is within 25 ft (7.6 m) of the indoor unit with no obstructions. If the remote is lost or damaged, contact a qualified service professional for a replacement. In the meantime, use the manual override mode to operate the system.
What to do if my Gree Air Conditioner wireless remote control is lost or does not work?
If your wireless remote control for the Gree Air Conditioner is lost or not working: * First, check and replace the batteries. * Ensure the remote is within 25 ft (7.6m) of the indoor unit without obstructions. If the remote is lost or damaged, contact a qualified service professional for a replacement. In the meantime, you can use the manual Override Mode to operate the evo system.
How to improve Gree GWH09AB-D3DNA2D Air Conditioner heating or cooling efficiency?
To improve the efficiency of your Gree evo system, which is designed for peak performance with routine maintenance: * Ensure there are no obstructions blocking the air flow into the room. * Clean or replace any dirty air filter that might be restricting air flow. * Seal any outdoor air leaks in the room from doors or windows. * If possible, relocate other heating sources in the room.
What to do if Gree Air Conditioner is leaking water inside?
If water is leaking from your Gree Air Conditioner's indoor unit into the room, first ensure the unit is level from right to left. Next, check the condensate drain tube for any restrictions or blockages, and remove them to allow continuous drainage. If the problem persists, contact a qualified service professional for assistance.
How to fix a Gree GWH09AB-D3DNA2D Air Conditioner that will not run?
If your Gree Air Conditioner system won't run, check if the circuit breaker is tripped or turned off. Also, ensure the power button on the remote is on and the remote's batteries aren't low. Finally, make sure the remote isn't in sleep or timer mode. If none of these resolve the issue, contact a qualified service professional.
How to fix a Gree GWH09AB-D3DNA2D that does not restart immediately?
The Gree Air Conditioner system has a built-in 3-minute delay to prevent rapid cycling of the compressor. Wait 3 minutes for the protection delay to expire.
General| Cooling Capacity | 9000 BTU/h |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Type | Split System |
| Noise Level (Outdoor) | 50 dB |
| Operating Temperature (Cooling) | 18-43 °C |
