68
Installation and Maintenance
Service Manual
Step Procedure
4. Remove rear case assy
(1)Remove the nger guard grille. Press the claps
at the top of the guard grille and then pull the nger
guard grille upwards to remove it.
(2)Loose the screws (2-3 circles) used for xing the
blade, pull the blade to the left side until it can’t be
pulled any more.
(3)Remove 4 screws used for fixing the bottom
case.
Press the concave position marked with red circle
with your thumb forcibly, lift the bottom case and
then pull it outwards.
5.Remove panel
Push the panel to the right side, pull the left side of
panel upwards to loose the clasp at the left side,
push the panel to the left and pull it upwards to
loose the clasp at the right side, and then remove
the panel. Remove the screws used for xing the
display board and then remove the display board.
(1)
(3)
(2)
Panel
Display
Screws
To Next Page
Loading...
