Indoor
Installation of indoor unit
outdoor
5-10
2.
right
Note:
Pay attention to dust prevention and
take relevant safety measures when
opening the hole.
rear left
right
cut off
the hole
1. Aim the pipe joint at the corresponding
bellmouth.
2.
pipe joint union nut
pipe
Pretighten the union nut with hand.
3.
30
Adjust the torque force by referring to the following sheet. Place the open-end
wrench on the pipe joint and place the torque wrench on the union nut. Tighten
the union nut with torque wrench.
left
When select leading out the pipe
from left or right, please cut off the
corresponding hole on the bottom
case.
Step four: outlet pipe
1. The pipe can be led out in the
direction of right, rear right, left or
rear left.
left
rear right
To Next Page
Loading...
