Gree GWH12AGB-K6DNA1A/O - Page 67

64
Technical Information
Service Manual
13.WiFi button
This function is only available for some models.
This function is applicable to partial of models.
● The Quiet function can be set up in all modes; Under the Quiet mode,the fan speed is not available.
● The Quiet function is only available for some models.
● When quiet function is selected
Under cooling mode: indoor fan operates at notch 4 speed. 10 minutes later or when indoor ambient temperature≤28℃, indoor fan will operate
at notch 2 speed or quiet mode according to the comparison between indoor ambinet temperature and set temperature.
Under heating mode: indoor fan operates at notch 3 speed or quiet mode according to the comparison between indoor ambient temperature and
set temperature.
Under dry, fan mode: indoor fan operates at quiet mode.
Under auto mode: the indoor fan operates at the auto quiet mode according to actual cooling, heating or fan mode.
Press " WiFi " button to turn on WiFi function, "WiFi " icon will be displayed on the remote controller;
Hold " WiFi " button for 5s to turn off WiFi function and " WiFi " icon will disappear.
Under off status, press "MODE" and " WiFi " buttons simultaneously for 1s, WiFi module will restore factory settings.
If “H1” is displayed on the remote controller while it’
s not operated by the professional person/after-sales person, it belongs to the misoperation.
Please operate it as below to cancel it.Under the OFF status of remote controller
, hold the Mode button for 5s to cancel “H1” display.
Note:
● If remote controller displays “H1”, it belongs to the normal function reminder
. If the unit is defrosting under heating mode, it operates accord-
ing to H1 defrosting mode. “H1” won’t be displayed on the panel of indoor unit
;
● Once you set H1 mode, if you turn of
f unit by remote controller, H1 will display 3 times on the remote controller and then disappear;
●
Also, when you set H1 mode, when you change to heating mode, H1 will display 3 times on the remote controller and then disappear.
Press "FAN" button to set your required fan speed: auto, low speed, low-medium speed,medium speed, medium-high speed,high speed.
If “H1” is displayed on the remote controller while it’s not operated by the professional person/after-sales person, it belongs to the misoperation.
Please operate it as below to cancel it.Under the OFF status of remote controller, hold the Mode button for 5s to cancel “H1” display.
Note:
● If remote controller displays “H1”, it belongs to the normal function reminder. If the unit is defrosting under heating mode, it operates accord-
ing to H1 defrosting mode. “H1” won’t be displayed on the panel of indoor unit;
● Once you set H1 mode, if you turn off unit by remote controller, H1 will display 3 times on the remote controller and then disappear;
● Also, when you set H1 mode, when you change to heating mode, H1 will display 3 times on the remote controller and then disappear.
Press "FAN" button to set your required fan speed: auto, low speed, low-medium speed,medium speed, medium-high speed,high speed.