Need help?Do you have a question about the Gree Sapphire SAP12HP230V1A and is the answer not in the manual?
General| Brand | Gree |
|---|---|
| Model | Sapphire SAP12HP230V1A |
| Category | Air Conditioner |
| Language | English |
General safety guidelines for electrical and installation procedures.
Criteria for selecting an appropriate location for the indoor unit, ensuring proper airflow and drainage.
Criteria for selecting an appropriate location for the outdoor unit, considering clearances and environmental factors.
Specifications and measurements for the indoor unit, including A, B, and C dimensions.
Steps for installing the indoor unit mounting bracket, ensuring proper alignment and secure attachment.
Detailed diagrams and measurements for mounting brackets for different unit sizes.
Specifications and measurements for the outdoor unit, including A, B, C, D, and E dimensions.
Procedures for mounting the outdoor unit on a ground pad or wall hangers, ensuring stability.
Instructions for installing riser legs for elevating the outdoor unit, aiding drainage and vibration absorption.
How to connect the condensate drain for the outdoor unit to ensure proper water disposal.
Steps and guidelines for drilling holes in the wall for refrigerant pipes and drain hoses.
Preparing refrigerant pipes before connection, including insulation and cleaning.
How to connect refrigerant pipes to the indoor unit, including torque specifications.
Recommended torque values for tightening flare nuts on refrigerant pipe connections.
How to connect refrigerant pipes to the outdoor unit, ensuring secure and leak-free connections.
Instructions for installing the indoor unit's drain hose, ensuring proper downward slope for gravity drainage.
Electrical diagrams showing connections for indoor and outdoor units for different models.
Steps for connecting wires to the indoor unit terminal block according to wiring diagrams.
Procedure for installing an optional disconnect switch for the indoor unit, if required by local codes.
Steps for connecting wires to the outdoor unit terminal block, ensuring secure and proper connections.
How to perform a leak test on the system using nitrogen and soap bubbles.
Steps for evacuating the system using a vacuum pump to remove air and moisture.
Testing pipe connections and procedures for adding refrigerant based on pipe length.
Verifying the condensate drain system functionality by adding water.
A step-by-step guide for initial system startup and operational checks.
Steps for cleaning the air filter of the indoor unit to maintain performance.
To Next Page