Placement of the module
4 Placement of the module
4.1 Wall mounted units
Connect sensor of room temperature (2-pin) to terminal located at upper side of PCB,
connected to mainboard, and lay it out concurrently with original factory sensor of room
temperature in the outdoor unit. Both PCBs have self-adhesive tape at bottom side.
Remove their protection layer and attach PCBs to plastic chassis of indoor unit (specific
placement can vary based on concrete model). Install display board and front panel to
original positions, installation is completed.
1. Connect room temperature sensor 2. Lay it out concurrently with factory
sensor
3. Attach PCB for connection to
mainboard via self-adhesive tape
4. Attach visual PCB to chassis under the
front panel
24 WiFi Module Gree
To Next Page
Loading...