Gree U-Match 6 Series - Page 100

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
97
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
4. Remove the compressor from
the chassis.
 Take out the compressor and
replace it.
Note: When replacing the
compressor, avoid touching
the nearby pipeline and
components.
5. Fix the new compressor back
onto the chassis.
 After replacing the
compressor, tighten up the
screws at the foot of
compressor.
6. Connect the compressor
suction port and exhause port
with the pipes.
 Weld the compressor
connection pipes and
connect them to the
compressor.
Note: When replacing the
compressor, avoid touching
the nearby pipeline and
components.
7. Connect the compressor
wires.
 Connect the compressor
wires to the wire terminals
on the top of compressor.
Note: When connecting the
wires, be sure to match the
colors with the
corresponding wire
terminals.