Gree U-Match 6 Series

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
96
Model: GUD35W1/NhA-S, GUD50W1/NhA-S, GUD71W1/NhA-S, GUD85W1/NhA-S
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels and wires.
 Remove the upper, lower
and front panels.
 Loosen the securing screws
of the wires with a
screwdriver.
 Remove the wires.
Note: When removing the
wires, mark the wire
terminals corresponding to
their color so as to avoid
misconnection.
2. Loosen the securing screws
at the foot of compressor.
 Use a wrench to twist off the
screws at the foot of
compressor.
3. Break off the pipes that
connecting to the compressor.
 Weld the pipes that are
connected to the
compressor.
 Then remove the pipes.
Note: When welding the
pipes, do not let the flame
burn the other components.