Gree U-Match 6 Series - Page 103

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
100
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step Picture Work instruction
5. Install the fan.
 Install the fan in place. Put
on the gasket and use a
wrench to secure the
screw nut.
Note: After installing the
fan, turn the fan by hand to
see if it can run normally. If
not, please check for the
reason.
6. Install the grill.
 After replacing the motor,
use a screwdriver to
tighten up the screw bolt
that secures the motor.
Model: GUD35W1/NhA-S,GUD50W1/NhA-S,GUD71W1/NhA-S,GUD85W1/NhA-S
Removal of condenser
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels.
 Remove the upper, lower and
front panels.
2. Remove the electric box.
 Loosen the wire clamp at the
bottom of the electric box.
 Unscrew the screws of electric
box.
 The connection wires inside and
outside the electric box should
be removed.