Central Air Conditioner Thermostat
14
5.8 Parameter setting
(1) After a stop of the unit, press keeping of both (SPEED) and
(UP) is an access to parameter setting page. Set the serial numbers of
parameters by tapping (MODE) and decide the parameter values by
(UP) or (DOWN).
(2) Next, press keeping of both (SPEED) and (UP) ensures saving
all the parameter values. Then, the parameter setting page automatically
exits. Whereas, the parameter setting page automatically exits, not saving
all values without any operation in 20 seconds.
(3) Parameter list:
S.N Name Description
01 Power failure memory ON: enable (by default); OFF: disable
02 Energy saving function ON: enable; OFF: disable (by default)
03 Drying function ON: enable; OFF: disable (by default)
04
Temperature unit setting
F: Fahrenheit; C: Celsius (by default)
05
Fan operation at
temperature set points
00: the fan works as to the set speed;
01: the fan works at the low speed;
02: the fan stops (by default)
06 Temperature calibration
Adjustable range: -5°C~+5°C (a precision of
0.5°C, 0°C by default)
To Next Page
Loading...
