13
Technical Information
Service Manual
6. Function and Control
6.1 Remote Controller Introduction
1
7
Press it to set HEALTH or AIR function.
8
I FEEL
/
4
3
2
5
6
Press it to start or stop operation.
ON/OFF
MODE
+
-
Press it to select operation mode
(AUTO/COOL/DRY/FAN/HEAT).
: Press it to increase temperature
setting.
: Pressittodecreasetemperature
setting.
FAN
Pressitset swing angle.
SWING
Press it to set fan speed.
3
15
5
4
14
7
13
12
9
8
11
10
2
1
6
Remote Controller Description
16
WiFi
T-ON T-OFF
11
13
12
16
10
14
9
15
QUIET
CLOCK
WiFi
TEMP
TURBO
SLEEP
LIGHT
Pressitto set
Pressitto set auto-off/auto-ontimer.
Pressitset clock.
Press it to turn on/off the light.
QUIET function.
ON/OFF:
+ :
1
3
2
Pressthisbuttontoturn on theunit.Pressthisbuttonagain to turn offthe unit.
Press this button to decrease set temperature. Holding it down above 2 seconds rapidly decreases
set temperature. In AUTO mode, set temperature is not adjustable.
Press this button to increase set temperat
ure.Holding it down above 2 seconds rapidly increases set
temperature. In AUTO mode, set temperature is not adjustable.
Note:
● This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function, which
the model doesn't have, if press the corresponding button on the remote controller that the unit will keep the original running
status.
MODE :
4
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL,DRY,
*
,asthe following:FAN,and HEAT
AUTO
C
OO
L
DRY
FANHEAT
*
*Note:Only formodelswithheating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LED of the indoor, and
the unit will automatically select the suitable operation mode in accordance with the room temperature to make indoor room
To Next Page
Loading...
Need help?
General
