IMPORTANT
This unit should be installed to current IEE wiring regulations if in doubt
consult a qualified electrician.
Volt Free Contact –
There is no voltage on the relay contacts (between terminals 3 & 4). So
you can switch any system up to 240V, 16A Resistive or 2A inductive.
You need to supply your own signal voltage to terminal 3. The voltage that
is present is whatever you supply.
Please ensure the load requirement across terminal 3 is protected by the
relevant circuit breaker as per latest regulations.
E. sales@greenbrook.co.uk
W. www.greenbrook.co.uk
To Previous Page
Loading...
