8
Security alert
9
!
Pay Attention
Check before use
Before using a motorcycle, be sure to check the following items
Table 1
Projects
Check content
Check operation, status, and free travel. Make adjustments if necessary.
Make sure that the performance of the brake is good, can be detected at low
speed.
Brake
Speed control
handle
Brake Lever
Tires/wheels
Parts/fasteners
Lights and signaling
devices
Check the operation, condition and clearance of the speed control handle
and adjust if necessary.
Check that the operation is flexible and smooth, and lubricate/adjust if
necessary.
Check tire pressure, wear and damage.
Check all chassis parts and fasteners. Tighten and adjust if necessary.
Check whether the lights, indicators are correct, whether the horn
performance is good.
Note:
● A pre-service check should be carried out every time the vehicle is used. If the above
items are in bad condition, should be in the car before the timely repair, so as to avoid
serious damage to the car, or an accident.
● please abide by the traffic rules consciously and strictly prohibit drunk driving.
If can carry on the operation, the maintenance strictly according to the above way, this
system life extension, uses in the handy, brings the greater economic benefit for you.
Tires (front tire pressure 35 PSI
, rear tire pressure 35PSI)
should be regularly checked and adjusted tire pressure.
(1) The tire pressure can be checked only when the tire is cooled
(2) Should always check whether there are puncture holes in the tire,
especially if there is a leak in the tire should be repaired immediately.
(3) Check the tread for cuts, nails or other sharp inserts, indentations, dents
or deformations.
(4) New Tires should be replaced when the tread pattern reaches the tread
wear limit mark.
Note:
Before driving an electric vehicle, you must be familiar with all the controls and
functions of the vehicle. If you are not familiar with the controls and functions,
please contact our sales department or our The Adjuster department.
3.4 Driving operation
1、 before starting the preparation: The car parking lock opened, to ensure that the
power switch in the state of the diagram, the key into the ignition switch, rotating to
the“ON” position can be; (as shown in the diagram)
2、Speed control handle-used to control the vehicle speed. To accelerate, turn the
KNOB in your direction and vice versa in the direction you leave.
3、Turn on your lights when driving at night.
Do not quickly rotate the operation of the Speed Control Knob,
otherwise, the thunder King Electric car will quickly forward, so that the
vehicle may lose control.
Security alert
3.5 Braking operation
（1）Control the speed control handle
To reduce the speed of the vehicle, it is important to reverse the slow
rotation of the speed control Knob and use the brake operation at the same
time.
Security alert
Avoid rough or emergency braking, otherwise there is the risk of
tipping; car turn, must slow down, carefully slow braking, otherwise
there will be the risk of bumpy car.
Security alert
Special Care must be taken when driving on wet or soft roads or in rainy
conditions, whether braking, accelerating or turning.
（2）Operation of the brake
When driving down a steep incline, turn it off completely and use the
rear brakes to slow down.
To Next Page
Loading...
