Greencut GTC3000E - Maintenance Schedule and Procedures; Engine Maintenance Tasks; Transmission and Drive System Maintenance

83
EN
MAINTENANCE
ATTENTION: When you have to carry out repairs or maintenance work use only original spare parts
to ensure maximum reliability of the machine.
ENGINE
Follow the rules indicated in the user manual.
MANTENIMIENTO EACH USE
EVERY
MONTH OR
24H USE
EVERY 3
MONTHS
OR 50H USE
EVERY 6
MONTHS
OR 100H
USE
EVERY YEAR
OR 300H
USE
Belt tension
Check X
Change X
Engine oil
Check level X
Change X X
Air lter
Check X
Clean X X
Replace X
Transmission
wheel
Check X
Replace X
Wheel pressure Check X
Shaft teeth Clean X
Half-shaft of
the wheel
Lubricate X
RUNNING-IN (50 HOURS)
During the rst 50 hours of operation of the machine do not do an
excessively hard work and follow the recommendations in the following
paragraph.
OILING THE AIR FILTER
Every 8 hours of work. Check the oil level and, if necessary, top up with
the same engine oil. Clean the lter element as indicated in the Engine´s
Use and Maintenance book.
NOTE: The cleaning frequency of the air lter
depends on the environmental conditions in which
the machine has been used; and it is recommended
not to exceed 8 working hours.
TRANSFER AND TRANSMISSION BOX
After the rst 50 hours of work (running-in). Change the oil (see gure
12). If the change of oil is done when the engine is hot, it facilitates the
ow of dirty oil.
1. Remove the oil ller cap (1)
2. Remove the drain plug (3) from the bottom of the box and empty
the oil, and then reinstall the plug (3).