What to do if Greenlee Construction Equipment bender will not operate?
If your Greenlee Construction Equipment bender isn't operating, first ensure that the switch is turned on. Also, check the supply voltage circuit operation to make sure there is voltage.
Why are bends overbent on Greenlee Construction Equipment?
If bends are overbent a few degrees when using Greenlee Construction Equipment, it might be due to too much squeeze on 1-1/2" or 2" EMT or IMC conduit. Back the squeeze off per the adjustment instructions. Alternatively, bend a smaller angle to compensate.
What to do if Greenlee Construction Equipment bends are underbent?
If bends are underbent a few degrees when using Greenlee Construction Equipment, it could be due to too little squeeze on 1-1/2" or 2" EMT or IMC conduit. Increase the squeeze per the adjustment instructions. Another approach is to bend a larger angle to compensate.
Covers symbol meanings, electrical, environmental, and physical hazards.
Ensures correct connection to a grounded receptacle for safety.
Instructions for installing shoes, supports, and marking conduit.
Step-by-step guide for bending conduit.
Instructions for creating 90-degree stub bends.
Guides for bending offsets around obstructions using tables.
Detailed steps for bending stubs and working past obstructions.
Procedure for adjusting the drive chain tension.
Addresses issues like bender not operating or incorrect bends.
Flowchart for troubleshooting circuit breaker trips.
General| Model | 555-22 |
|---|---|
| Bending Shoe Included | Yes |
| Capacity | 1/2 - 2 in EMT, 1/2 - 2 in Rigid, 1/2 - 2 in IMC |
| Conduit Size | 1/2" to 2" |
| Bending Capacity (EMT) | 1/2" to 2" |
| Bending Capacity (Rigid) | 1/2" to 2" |
| Bending Capacity (IMC) | 1/2" to 2" |
| Construction | Steel |
To Next Page
