ETS12 Single Use Lock Cutter and Bolt Cutter
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
4
Pinch points:
Keep hands away from the cutting
head when cutting.
Failure to observe this warning could
result in severe injury or death.
Do not dispose of batteries in a re. They will vent
fumes and may explode.
Failure to observe this warning could result in severe
injury from harmful fumes or burns from ying debris.
Inspect tool before use. Replace any worn or
damaged parts. A damaged or improperly assembled
tool can break and strike nearby personnel.
Failure to observe this warning could result in severe
injury or death.
Do not operate the tool without cutting blades.
Damage to the ram or cutting head can result.
Do not twist work piece or tool during cutting
operation. Blade failure could result.
This tool is not designed for continuous use. After
100 cutting cycles, allow the cutting tool to cool for
15 minutes.
Do not place the tool in a vise. The cutting tool is
designed for hand-held operation.
This tool may be used in damp or wet environ-
ments; however, we recommend air-drying the tool
before use if it becomes soaked.
Use this tool for the manufacturer’s intended
purpose only.
Failure to observe these precautions may result in
injury or property damage.
•
•
•
•
•
•
Do not allow anything to contact the battery
terminals.
Do not immerse the batteries in liquid. Liquid may
create a short circuit and damage the battery. If
batteries are immersed, contact your service center
for proper handling.
Do not place the battery into a pocket, tool pouch,
or tool box with conductive objects. Conductive
objects may create a short circuit and damage the
battery.
Do not place a battery on moist ground or grass.
Moisture may create a short circuit and damage the
battery.
Failure to observe these precautions may result in
injury or property damage.
•
•
•
Do not store the battery at more than 60 °C
(140 °F). Damage to the battery can result.
Do not use another manufacturer’s charger. Other
manufacturers’ chargers may overcharge and
damage the battery.
Do not attempt to open the battery. It contains no
user-serviceable parts.
Failure to observe these precautions may result in
injury or property damage.
•
•
•
Do not perform any service or maintenance other than
as described in this manual. Injury or damage to the
tool may result.
Failure to observe this precaution may result in injury
and property damage.
Note: Keep all decals clean and legible, and replace
when necessary.
IMPORTANT SAFETY INFORMATION
To Next Page
Loading...
Need help?
General
