EN
Stand fan | Instruction manual38
Assembling the fan
1. Take all of the appliance parts out of the packaging and remove all
packaging materials and inserts.
2. Take the up cross base (22), put it into the down cross base (24),
and xed by a base xed screw (17). After that, put the 4-pcs base
plastic cover (23) into each side of the cross base.
3. Take the base plastic cover (21), put it across the holder, and cover
the base well.
4. Take the main body, put it into the upholder (15), and xed by xed
screw (14).
5. Take the back grill (5), put it on the motor (6), and xed by grill lock
nut (4).
6. Take the blade (3), put it into the motor (6), and xed by blade lock
nut (2).
7. Take the front grill (1), and put it to match the back grill (5) and x
them by xed screw (11) and xed nut (10).
SPEED FUNCTION
There are 3 speeds to select.
1 - Low speed
2 - Mid speed
3 - High speed
0 - The power off button to stop the fan from working
OSCILLATION
Lift the oscillation button, and the fan will ow at one angle at all.
Press down the oscillation button, and the fan will ow from left to
right.
It can also select the fan ow from up and down, by adjusting the fan
ow angle.
Noted: The height of the fan can be adjusted, by screwing off the holder lock nut
(16).
To Next Page
Loading...
Need help?
General
