GreenTech Pureheat 2-in-1 User Manual

7
UNIT SETUP
1. Unpack the unit by cutting open taped areas. Fold back box aps and gently
turn entire box upside down. Lift box off of styrofoam packed contents. Remove
styrofoam, turn upright. We recommend keeping packing materials for future
transport or storage of unit.
2. Find a level and unobstructed location to place heater away from cold walls
(outside walls).
3. Plug the POWER CORD into a grounded outlet (120V, 15A or higher).
4. Activate the REMOTE by removing the plastic shipping guard from the battery
compartment.
INSPECT THE PUREHEAT 2-IN-1 FOR DAMAGE BEFORE SETUP OR USE.
USING PUREHEAT 2-IN-1
READ ALL WARNINGS & CAUTIONS (PAGE 4) BEFORE USING YOUR PUREHEAT 2-IN-1.
Turning the Unit On/Off
• Turn the unit on by pressing the “I” on the POWER TOGGLE (Unit Rear).
• Turn the unit off by pressing the “O” on the POWER TOGGLE (Unit Rear).
• Always unplug the unit when not in use.
Heater Mode
• Press the HEATER CONTROL button to activate the Heater Mode. (This will also
automatically activate Purier Mode. To toggle Purier Mode on or off, press the
PURIFIER CONTROL button.) Set the desired temperature using the TEMPERATURE
CONTROL buttons. You may select a temperature from 60 to 90 degrees Fahrenheit.
Purier Mode
• Toggle the Purier Mode on or off at any time that the unit is turned on by pressing
the PURIFIER CONTROL button.

GreenTech Pureheat 2-in-1 Specifications

General

Brand	GreenTech
Model	Pureheat 2-in-1
Category	Heating System
Language	English