Unpack and identify all parts carefully Use the list below as a guide.
Assembly
The reservoirs we supply with the
system are blue with a white removable
lid. The lid has a four inch hole cut in
it. If you’re using a different reservoir,
you will need to cut a four inch hole in
the top and have a way to attach the
Fill/Drain Tube Mount.
Insert 10 of the ¾” Connectors into the grommets at the base of the
Controller.
NOTE: A small amount of lubricant like water, or dish soap and
water will make installing the connectors into the grommets much
easier.
Items included with the 12 pot system
1 Controller Assembly
2 6 pot Add-On Kits
1 55 gallon reservoir
Items included with the 24 pot system
1 Controller Assembly
4 6 pot Add-On Kits
1 55 gallon reservoir
Items included with the 36 pot system
1 Controller Assembly
6 6 pot Add-On Kits
1 55 gallon reservoir
Items included with the 48 pot system
1 Controller Assembly
8 6 pot Add-On Kits
1 55 gallon reservoir
The Controller Assembly contains
1 Controller with timer.
2 Pumps, one Fill Pump and one Drain Pump
1 15 foot Roll of ½” Tubing
1 3 foot Roll of 5/8” Tube Wrap
1 Fill/Drain Tube Mount
1 Lid for Controller
5 ¾” Elbows
2 ½” Elbows
15 ¾” Connectors
10 ¾” Barbed Fitting End Caps
1 1-5/8” Screw
1 Instruction manual
Each 6 add on contains
6 Lower Pots with grommet installed
6 Upper Pots with drain holes
6 Tee fittings
1 Elbow fitting
1 Roll of ¾” tubing, approximately 20 feet
To Next Page
Loading...