To Next PageTo Next Page
Need help?Do you have a question about the Greenwood SK200A and is the answer not in the manual?
General| Model | SK200A |
|---|---|
| Brand | Greenwood |
| Category | Fan |
| Voltage | 220-240V |
| Frequency | 50Hz |
| Color | White |
| Material | Plastic |
Important safety warnings regarding appliance usage, siting, and supervision of children.
Details on the operation and control options for various SK200 fan models.
Crucial safety instruction: isolate mains power before performing any maintenance on the fan or filter.
Guidance on unit mounting orientation, wall entry, and clearance from the floor.
Instructions for selecting cable entry and preparing the wall cut-out for rear exit.
Procedure for fitting the cover screws and replacing the grille.
Important warning to avoid distorting the backplate during fitting.
Step-by-step guide to safely remove the fan cover using a screwdriver.
Important warning to avoid distorting the backplate during fitting.
Instruction to remove the shutter flap when using flexible ducting.
Guidance on tightening screws to securely fix the fan unit.
Cutting ceiling opening and terminating the mains supply cable into the isolator.
Fitting the cosmetic sleeve and locating the fan onto the backplate.
Installing 100mm duct and external grille/baffle for soffit or wall.
Steps for preparing the ceiling, including hole diameter and shutter flap.
Fixing the backplate, wiring, and mounting the fan assembly.
Steps for preparing the ceiling, including template use and fitting for side/rear exhaust.
Procedure for fitting the fan assembly into the prepared ceiling recess.
Electrical connection requirements, safety precautions, and regulatory compliance.
Details on power consumption and specification for different fan models.
Diagrams illustrating wiring for various switch and remote control operations.
Instructions for adjusting the minimum and maximum timer settings.
Guide to adjusting humidity sensitivity for higher or lower activation rates.
Important note that SK200MA adjustments must be carried out by a qualified electrician.
