19
TROUBLESHOOTING
PROBLEM
Unit will not blow
or mulcher.
1. Bag full
2. Blocked tube
3. Blocked impeller
4. Dirty bag
5. Torn bag
6. Bag unzipped
7. Unit unplugged
1. Empty the bag.
2. Clear the blockage.
3. Clear the blockage
4. Clean the bag.
5. Replace the bag.
6. Zip up the bag.
7. Plug into an outlet or an extension
cord.
Unit will not start.
1. Unit is unplugged.
2. Power/speed switch is in
the OFF position.
3. Defective power switch.
4. Vac tubes are not correctly
installed.
5. Intake gate/cover is not
closed.
6. House circuit may have
tripped.
1. Check cord to make sure it is plugged
into an electrical outlet.
2. Slide switch to high or low.
3. Call toll free helpline: 1-888-909-6757.
4. Check vac tubes to ensure that they
are allowing the switch to be engaged
when correctly installed.
5. Ensure that gate/cover is fully closed
an locked.
6. Check wall circuit breaker panel and
reset if necessary.
POSSIBLE CAUSE SOLUTION
To Next Page
Loading...
