GreenWorks G24JACK - User Manual

Questions and Answers

O
omorrisJul 30, 2025
Why my GreenWorks Jacks does not turn on?
- N
  Natalie PearsonJul 30, 2025
  Your GreenWorks Jacks might not be turning on due to a few reasons. First, check if the power switch is in the correct position; if it's set to “O”, switch it to “ | ”. Alternatively, the battery pack may be out of charge, so try charging it. If neither of these steps works, the power switch may be defective, and you should contact an authorized dealer for assistance.
P
pvaughnAug 6, 2025
What to do if the piston does not raise on my GreenWorks Jacks?
- J
  justin17Aug 6, 2025
  If the piston on your GreenWorks Jacks isn't raising, there could be several reasons. Ensure the power switch is in the “ | ” position instead of “O”. Also, make sure the battery pack is fully charged. If the hydraulic oil temperature is too low, move the jack to a warmer area to allow the oil to warm up. Check that the release valve is closed. If air has entered the hydraulic system, contact an authorized dealer for assistance.
R
Rachel HernandezAug 14, 2025
What to do if the piston does not lower on my GreenWorks Jacks?
- D
  David BradleyAug 14, 2025
  If the piston on your GreenWorks Jacks isn't lowering, there are a few potential causes. Check that the power switch is in the “ | ” position instead of “O”. Also, ensure the battery pack is charged. If air has entered into the hydraulic system, contact an authorized dealer for assistance.
T
tracy85Aug 21, 2025
How to fix GreenWorks G24JACK that does not sit level?
- D
  davidyangAug 21, 2025
  If your GreenWorks Jacks isn't sitting level, it might be because the base plate screw has backed out. To fix this, remove the base plate screw, apply blue thread locking compound, and then reinstall the base plate screw.