1 DESCRIPTION
1.1 PURPOSE
This machine is used to cut grass, light weeds, and
other similar vegetation at or around ground level. The
cutting plane must be approximately parallel to the
ground surface. You cannot use the machine to cut or
chop hedges, shrubs, bushes, flowers and compost.
1.2 PRODUCT OVERVIEW
Figure 1-22 .
1
Battery slot
2
Rear handle
3
Lock-out button
4
Speed button
5
On/off button
6
Trigger
7
Carrying ring
8
Auxiliary handle
9
Upper shaft
10
Coupler
11
Lower shaft
12
Guard
13
Cutting blade
14
Trimmer head
15
Cut-off blade
16
Guard cap
17
Release button
18
Positioning hole
19
Knob
20
Lower clamp
21
Battery release button
22
Spool cover
23
Spool
24
Bump knob
25
Spool cover line slot
26
Slot
27
Line slot
28
Trimmer head tool
29
Inner cup
30
Plate
31
Outer cup
32
Nut
A
Direction of rotation
B
Best cutting area
C
Dangerous cutting area
2 SAFETY
WARNING
Make sure that you follow all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
WARNING
Remove the battery pack from the machine before
installation.
WARNING
Do not use accessories that are not recommended for
this machine.
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If parts of the machine are damaged, do not use
the machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
WARNING
For your personal safety, do not insert battery before
the tool is assembled completely.
3.2 ATTACH THE GUARD
Figure 2.
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
Phillips screwdriver (not provided).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4
English
EN
To Next Page
Loading...
