• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
5.2 CLEAN THE COLLECTION BAG
• Wear safety glasses and a dust mask.
• If it is necessary, clean the bag 1 time a year or
more.
1. Remove the bag.
2. Turn the bag inside out.
3. Hang the bag up and clean it.
4. Hang the bag to dry.
5. Turn the bag right-side out and install it again.
5.3 CLEAN A BLOCKED TUBE /
IMPELLER
1. Wait until the machine fully stops.
2. Remove the blower tube or mulcher tubes and the
bag.
3. Remove the material that causes a blockage of the
tube or impeller.
4. Make sure that the impeller has no damage.
5. Turn the impeller with the hand to make sure that
there is no blockage.
6. Install the blower tube or mulcher tubes and the
bag.
WARNING
Avoid the intake of large objects that could damage
the impeller.
6 TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
tranportation and storage.
6.1 MOVE THE MACHINE
• Only hold the machine with the handgrip.
6.2 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
7 TROUBLESHOOTING
PROBLEM POSSIBLE
CAUSE
SOLUTION
The ma-
chine does
not blow or
mulch.
The tube has
blockages.
Make sure that the
tube is clear.
The impeller has
blockages.
Make sure that the
impller is clear.
The bag is full. Empty the bag.
The bag is dirty. Clean the bag.
The bag has
damage.
Replace the bag.
The bag is unzip-
ped.
Lock the bag.
The battery pack
is not secure.
Make sure that you
latch the battery
pack correctly.
The battery ca-
pacity is low.
Charge the battery
pack.
The ma-
chine does
not start.
The on/off button
is in the OFF po-
sition.
Push the on/off but-
ton.
The on/off button
is defective.
Replace the defec-
tive parts by an ap-
proved service cen-
tre.
The tube is not in-
stalled correctly.
Make sure that you
install the tube cor-
rectly.
The gate is not
locked.
Make sure that you
lock the gate.
The battery pack
is not secure.
Make sure that you
latch the battery
pack correctly.
The battery ca-
pacity is low.
Charge the battery
pack.
6
English
EN
To Next Page
Loading...
