To Next PageTo Next PageHow to fix GreenWorks Trimmer line that does not extend?
If the line on your GreenWorks Trimmer isn't extending, several factors could be at play. The lines might be stuck together; try lubricating them with silicone spray. You might not have enough line on the spool, so try installing more. The lines could be worn and too short, in which case, extend the line. Or, the lines might be tangled on the spool; remove them and wind them again.
Why doesn't my GreenWorks GD60LT Trimmer start when I push the trigger?
If your GreenWorks Trimmer doesn't start when you push the trigger, here's what to check: * Make sure there's good electrical contact between the trimmer and the battery. Remove the battery, inspect the contact points, and then reinstall the battery securely. * The battery pack might be empty. Try charging it. * Ensure you're pressing the lock-out button and the trigger simultaneously. First, pull and hold the lock-out button, then pull the trigger to start the trimmer.
How to fix a GreenWorks GD60LT Trimmer when the line does not advance?
Here's how to address a GreenWorks Trimmer line that won't advance: * If the lines are stuck together, try lubricating them with silicone spray. * If there's not enough line on the spool, install more line. * If the lines are worn too short, advance the cutting line. * If the lines are tangled on the spool: 1. Remove the lines from the spool. 2. Rewind the lines neatly.
Why does the line keep breaking on my GreenWorks Trimmer?
If the line on your GreenWorks Trimmer keeps breaking, it might be due to incorrect usage. Try these tips: * Cut with the tip of the line, and avoid hitting stones, walls, or other hard objects. * Advance the cutting line regularly to maintain a full cutting width.
How to stop grass from winding around the trimmer head of my GreenWorks GD60LT?
To prevent grass from winding around the trimmer head and motor housing of your GreenWorks Trimmer, avoid cutting tall grass at ground level. Instead, cut tall grass from the top down, removing no more than 8 inches in each pass.
What to do if my GreenWorks GD60LT line does not cut well?
If the line on your GreenWorks Trimmer isn't cutting well, the cut-off blade may be dull. Sharpen the cut-off blade with a file or replace it.
Why is the vibration on my GreenWorks GD60LT increasing?
If the vibration of your GreenWorks Trimmer increases noticeably, it could be because the line is worn down on one side and hasn't been advanced. Ensure the line on both sides is normal and advance the line.
Why GreenWorks Trimmer does not start?
If your GreenWorks Trimmer doesn't start when you push the trigger, there could be a few reasons. First, check that the battery pack is making good electrical contact with the trimmer by removing and reinstalling it. Also, make sure the battery isn't depleted – if it is, charge it. Finally, ensure you're pressing the lock-out button and trigger simultaneously to start the trimmer.
What to do if GreenWorks GD60LT stops when cutting?
If your GreenWorks Trimmer stops while you're cutting, it could be due to a couple of things. First, make sure the guard is properly attached to the machine; remove the battery pack before attaching the guard. Also, ensure you are using the correct cutting line diameter (2.0 mm/2.4 mm).
What to do if GreenWorks Trimmer battery pack is disconnected?
If the battery pack is disconnected from the GreenWorks Trimmer, reinstall the battery pack again.
General| Brand | GreenWorks |
|---|---|
| Model | GD60LT |
| Category | Trimmer |
| Language | English |
