GreenWorks GWSN20130 User Manual (English)

Other manuals for GreenWorks GWSN20130

Questions and Answers:

G
gwattsAug 10, 2025
Why won't my GreenWorks GWSN20130 Snow Blower start?
- T
  Theresa OrrAug 10, 2025
  If your GreenWorks Snow Blower won't start, it could be due to a few reasons. First, the extension cord might not be properly connected to the plug on the snow thrower; ensure they are securely connected. Second, the extension cord might not be connected to a power source; make sure it's plugged into a live 120 V AC, 60 Hz outlet. Finally, the switch may be defective, in which case it should be replaced by an authorized service center.
S
sanderstammyAug 15, 2025
What to do if my GreenWorks GWSN20130 Snow Blower doesn't start?
- M
  Michael RobersonAug 15, 2025
  If your GreenWorks Snow Blower isn't starting, there are a few potential reasons. First, the extension cord might not be properly connected to the plug on the machine; ensure these are securely connected. Second, the extension cord may not be plugged into a functioning power source; plug it into a live 120 V AC, 60 Hz outlet. Finally, the switch itself could be defective, in which case you should have the switch replaced by an authorized service center.
K
Kelly DavisAug 20, 2025
What to do if the motor is on, but the impeller doesn't turn on my GreenWorks Snow Blower?
- B
  Briana DickersonAug 21, 2025
  If the motor of your GreenWorks Snow Blower is running but the impeller isn't turning, the belt is likely damaged. You should replace the belt.
C
Courtney MuellerAug 26, 2025
Why does my GreenWorks GWSN20130 Snow Blower leave a thin layer of snow behind?
- W
  wilsonchristopherAug 26, 2025
  If your GreenWorks Snow Blower leaves a thin layer of snow behind, the scraper might be worn or damaged. Inspect the scraper and replace it if necessary.
A
Anthony MurrayAug 30, 2025
How to fix a GreenWorks Snow Blower handle that is not in position?
- J
  Jon ThomasAug 30, 2025
  If the handle of your GreenWorks Snow Blower is not in position, ensure that the bolts are correctly installed through the handle bars and that the hand knobs are tight.
M
Michelle FitzgeraldSep 4, 2025
How to fix the handle if it is not in position on GreenWorks GWSN20130?
- D
  David JohnsonSep 4, 2025
  If the handle of your GreenWorks Snow Blower is not in the correct position, it might be because the bolts are not engaged correctly. To fix this, adjust the height of the handle and ensure that the knobs and bolts are aligned properly.

GreenWorks GWSN20130 Specifications

General

Power Source	Battery
Voltage	80V
Auger Type	Single-Stage
LED Lights	Yes
Motor Type	Brushless
Battery Included	Yes
Charger Included	Yes
Clearing Width	20 inches
Clearing Depth	13 inches
Intake Height	10 inches
Throw Distance	20 feet