GreenWorks MO60L519 - User Manual

Questions and Answers

L
Lance HernandezAug 10, 2025
What to do if my GreenWorks MO60L519 stops during mowing?
- E
  elliottalexandraAug 10, 2025
  If your GreenWorks Lawn Mower stops during mowing, several factors could be at play. The blade height might be too low, so try increasing it. The battery could be out of power; in that case, charge the battery. Grass clippings might be tangled in the deck or blade, so remove the battery and check the deck. Lastly, the operating temperature of the product might be too high; turn it off and move it to a shaded area for 10-15 minutes.
E
Edward TaylorAug 15, 2025
How to fix a GreenWorks MO60L519 that won't start?
- T
  Troy OwensAug 15, 2025
  If your GreenWorks Lawn Mower isn't starting, the battery capacity could be low, so charge the battery. Alternatively, the blade engagement lever might be defective, requiring a replacement.
S
Shawn GriffinAug 20, 2025
What to do if my GreenWorks MO60L519 Lawn Mower does not mulch correctly?
- J
  joycepayneAug 20, 2025
  If your GreenWorks Lawn Mower isn't mulching correctly, it could be due to a couple of reasons. Wet grass clippings may be tangled in the deck, so wait until the grass dries before mowing. Alternatively, the mulch door might be missing, so install the mulch door.
N
Natasha MurrayAug 26, 2025
Why does my GreenWorks MO60L519 Lawn Mower cut grass unevenly?
- A
  Alicia MorrisAug 26, 2025
  If your GreenWorks Lawn Mower cuts grass unevenly, it might be because the blade height is too low. To resolve this, move the wheels to a higher position.
A
Allen BergerAug 30, 2025
Why is my GreenWorks MO60L519 Lawn Mower so hard to push?
- M
  Michael WilliamsAug 30, 2025
  If your GreenWorks Lawn Mower is hard to push, it could be due to a couple of reasons. The grass might be too tall, or the blade height is too low, so try increasing the blade height. Alternatively, the grass catcher and the blade might be dragging in thick grass, so empty the grass clippings from the grass catcher.
C
Cynthia BrooksSep 4, 2025
Why is there a high vibration in my GreenWorks MO60L519?
- U
  ubartonSep 4, 2025
  A high vibration in your GreenWorks Lawn Mower could stem from two issues. The blade might be unbalanced and worn, necessitating a replacement. Alternatively, the motor shaft could be bent. If this is the case: 1. Stop the motor. 2. Remove the battery. 3. Disconnect the power source. 4. Inspect for damage. 5. Repair the product before you start it again.

GreenWorks MO60L519 Specifications

General

Power Source	Battery
Voltage	60V
Deck Material	Steel
Cutting Height	1.5 - 4 inches
Drive Type	Rear Wheel Drive
Brushless Motor	Yes
Cutting Height Range	1.5 - 4 inches
Cutting Height Positions	7
Battery Included	Yes
Charger Included	Yes
Foldable Handle	Yes
Mulching Capability	Yes
Side Discharge	Yes
Bagging Capability	Yes
Battery	60V Lithium-Ion
Cutting Width	21 in
Warranty	4 years