Need help?Do you have a question about the GREER Company MG-534 and is the answer not in the manual?
General| Brand | GREER Company |
|---|---|
| Model | MG-534 |
| Category | Touch Panel |
| Language | English |
Lists necessary tools like nut drivers, levels, and measuring tapes for calibration.
Explains how to convert measurements and weights into the required format for the system.
Details the procedure for zeroing the boom extension sensor.
Details the procedure for zeroing the boom angle sensor using a level or inclinometer.
Explains how to measure and enter the boom angle for calibration.
Details the steps to set the zero point for the swing potentiometer.
Describes how to calibrate the swing potentiometer direction setting.
Details the first set of measurements for radius/moment calibration (tare load and radius).
Details the second set of measurements for radius/moment calibration (extending boom to 50%).
Details the third set of measurements for radius/moment calibration (extending boom to full).
To Next Page
