EasyManua.ls Logo

Gregoire Besson SP9 COMPACT - Page 27

Default Icon
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation manual SP 9 - Compact
CHAPTER II – GENERAL SAFETY – Page 13
2.24. PAY ATTENTION TO THE FLUIDS AND GASES UNDER THE
PRESSURE
Because of outflow of fluids under the pressure you can be injured if it
penetrates on your skin
or into your eyes.
In order to avoid the accident before the connecting or disconnecting the
hydraulic tubes you must always cease the pressure. That is why after stopping
the tractor and disengaging the plough and putting it on the ground, move the
hydraulic distribution lever from the front – back in order to discharge
the oil
from the pressure.
Before the putting the hydraulic system under the pressure examine the units, connecting pa
rts
(joining, tub
es, their flexibility) if they are under the suitable
conditions.
Wear thick gloves and goggles!.
NEVER try to find leaka
ge with your hand.
Use a stick and wear thick leather gl
oves.
For the better safety use suitable g
oggles.
Keep away from any kind of leakage
!
If because of any fluid under the pressure you are injured at once to
see a doctor! Any fluid which penetrated onto your skin, remo
ve it as
quickly as
possible or it may cause gangrene which leads to
amputation or even death.
Every doctor who do not know this type of injury should turn to the
specialist.
2.25. PRECAUTIONS IN THE CASE OF PLOUGH WITH LARGE
QUANTITY OF RESIDUE OR VEGETATION
If we use th
e plough on such fields where there is large quantity of stubble residue or vegetation
(corn, green manure) it is important to examine if the bottom pins of the pulling device have been
properly attached and the present of the safety-pin as the corn stems sometimes can tear them
out.
Under such conditions it is recommended to mount the safety-pin protection or use lock bolt or
brake-screws. Connect the GRÉGOIRE-BESSON dealer who can give you good advice.
2.26. PREPARATIONS FOR MAINTENANCE AND SERVICE
o The machine owner or user is responsible for maintenance.
o
Before every usage examine the equipment and machine blocking system
.
o
Systematically examine the connections and tubes condition
.
o
Be completely aware of the machine main
tenance before you perform any the smallest
intervention.
The instructions about precautions of maintenance and
usage of the machine you can fin din the chapter „Greasing
and maintenance”.