Operation manual SP 9 - Compact
CHAPTER XI - GREASING AND MAINTENANCE –- Page 2
10.2.1. APPLY SAFETY PRACTISE
Show responsible and competent attitude:
¾ At once change all the damaged spare parts,
¾ Change the worn and broken spare parts,
¾ Keep the spare part sin good condition and properly mounted,
¾ Put on the place chain-cases and equipment. If it is needed change them,
¾ Gathered grease, oil or other pollution must be eliminated and the spare part must be
cleaned,
¾ After finishing the maintenance be sure that there are no any spare parts or tools on the
way of the wheels,
¾ If several persons work on the plough, make sure that every task has been fulfilled (for
example, all screws has been put back).
IMPORTANT: If on the original plough we perform any modification, the manufacturer do not
take any responsibility and refuse the guarantee.
11.2.2. BEFORE INSPECTION HOSE DOWN THE MACHINE
¾
Before any
maintenance find time to hose down the
machine and clean it fro
m the dirt. It is easier to do the
inspection and adjustment as well as it is easier to
keep clean the area of
maintenance
BE CAREF
UL with the stream under big pressure:
¾
The power of the str
eam under big pressure may
cause injury
on the body or in the ey
es. Use the hose
accordingly.
¾
Be careful, do not damage or pull
down the security
matrixes on the plough.
Put the new ones instead of
damaged or missed.
¾
If you use washing equipment with big pressure, do not
keep it too close to the machine and do not direct the
stream to the electric equipment, connections,
hydraulic pipes, contacto
rs etc.
¾
After the cleaning check the hydraulic flexible pipes and be sure that they do not leak,
that the connections are not loosen
or damaged.
¾
If you notice any damage, repair it at
once.
¾
After washing grease the machine, by this you can clear way the water from axle of the
articulated connections and
rings.
To Next Page
Loading...