Operation manual SP 9 - Compact
CHAPTER XI - GREASING AND MAINTENANCE –- Page 10
11.2.20. REMINDER
The best assurance ag
ainst accidents is a CAREFUL AND ATTENTIVE
user. The risk of danger increases if you are in a hurry or tired. If you have
any question about any part if this instruction or plough usage connect our
GRÉGOIRE-BESSON dealer.
11.3. FASTENING OF BOLTS
Before starting to use the plough be sure that every bolt and screw are fastened accordingly.
After 50 working hours check every fastening and fixing, then before every season.
Every day pay special attention to:
¾
bolt of wheels,
¾
screwing of the wearing pieces during the usage on the gravel ro
ads (big
vibration),
¾
plough bottoms, if they are mounted with plastic
breasts.
11.4. LUBRICATION / GREASING
The adaptable greasing and lubricating of the moving parts provides the GREGOIRE-
BESSON plough long life and performance. The lubricants can be found on every rotation
point. The lubrication provides the suitable work of the articulated axles and vanishing of
the dust out of axle-journals. Use the Unil – Opal MOS2 lubricant or the same quality
lubricant. Clean the lubricators well before filling the lubricant into it. The impurities can
close the pipes or passages. If the lubricator is plugged or worn, change it or clean it.
During lubrication check the uninterrupted movement of the lubricant. If the lubricant
overflow mixes with dust it can form the mass of abrasive effect. The over flown lubricant
should be cleaned away.
The frequency of the lubrication is set for general usage of the machine you should pay
additional attention if you work under hard or special soil conditions.
Study the Varilibre plough lubrication on the next page.
The lubrication contains:
¾ The position of every lubricator on th
e plough.
¾
The number of handling
lubricators.
¾
The 2 pictograms symbolize the frequency of the lubrication
on every part of the
plough:
¾
Lubrication after every 48 working h
our.
¾
Lubrication after every 24 working h
our.
To Next Page
Loading...