6 of 23 08/18
W:\ELECTRICAL\MANUAL\BENCH\GENERAL INSTRUCTIONS\BENCHOVEN INS.8-18
2-5 MAINTENANCE AND INSPECTION
2-5.1 Regularly scheduled inspection and maintenance of all safety devices shall be
performed by user. Failure to do this may result not only in fire or explosion
damage, but also contribute to accidental shutdowns and loss of production. See
Section 7 - AMaintenance@ and Appendix B - AMinimum Periodic Maintenance
Report@.
2-5.2 Regularly scheduled inspection of the oven interior, heat chamber and ductwork
shall be performed by user to determine need for cleaning and repair. Failure to
do this may result in internal fires or component failure resulting in oven damage
and loss of production.
2-5.3 It shall be the sole responsibility of the user to establish, schedule and enforce the
frequency of and the extent of the inspection/maintenance program (as well as the
corrective action to be taken) because only the user can know what the actual
operating conditions are. Contact your insurance authority, Factory Mutual or the
National Fire Protection Association, whose addresses are listed in Appendix B, for
more information on inspection/maintenance programs.
2-6 RETROACTIVITY
This equipment has been designed and manufactured in accordance with applicable
National Codes in effect as of the date of manufacture. It is the responsibility of the end
user to update equipment as necessary to comply with future code changes. If you are in
doubt, contact manufacturer to review your equipment design against current National
Codes.