15
COMMISSIONING
COMMISSIONING REMOTE ACCESS DEVICES
NOTE: The transmitter supplied with your operator is
preprogrammed by the factory.
Program the Receiver to Match Additional Transmitter Codes:
Using the yellow “LEARN” Button
1. Press and Hold the button on the hand-held remote or wall
button that you wish to use (1).
2. Press and release the yellow “LEARN” buton on the operator (2).
3. Release the remote button. When the LED indicator flashes the
operator has learned the code. If you release the remote control
push button before the operator light flashes, the operator will not
learn the code.
Now the operator will activate when the remote control push
button is pressed.
To Erase all Remote Control Codes
1. Press and Hold the yellow “LEARN” button on the operator until
the indicator LED goes ON, and continue holding for approx. 6
seconds, until the indicator LED goes out.
2. Release the button, all codes are now erased.
Wireless Keypad E840G
To set the keyless entry PIN:
1. Locate the yellow “LEARN” button on the door operator.
2. Press and release the yellow “LEARN” button. The LED indicator
light will glow steadily.
3. Enter a 4-digit personal identification number (PIN) of your choice
on the keypad.
4. Press and hold the ENTER button. Check to see if the operator
light flashes. Release the ENTER button after the light flashes.
To change an existing keyless entry PIN:
1. Enter the existing programmed PIN that you want to change.
2. Press and hold the # button until the LED indicator light flashes
twice.
3. Enter the new 4-digit PIN of your choice, then press the ENTER
button. The light will flash once.
4. To test, enter the new PIN, then press the ENTER button. The
operator will activate.
Activate the operator only when door is in full
view, free of obstruction and properly
adjusted. No one should enter or leave garage
while door is in motion. Do not allow children
to operate push button(s) or remote(s). Do not
allow children to play near the door.
WARNING
2. Yellow Learn Button
Locate the Yellow Learn
Button
Press & Release Yellow
Learn Button
Enter a 4-digit code of
your choice
Press & hold the Enter
Button until the Operator
light flashes
After the lights flash
release the Enter button
1.
To Next Page
Loading...
Need help?
General
