EasyManuals Logo

Grifco MH Series User Manual

Grifco MH Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
AUTO CLOSE AND WIRELESS ACCESSORY SETUP
Action Button Sequence
LEARN THE E138G
WIRELESS WALL CONTROL
FROM THE CONTROLLER
The E138G can be used as a two channel wireless wall control for use on one or two doors, or as a
dedicated up/down wireless wall control. In either application for the door to latch down an
Entrapment Protection Device must be installed. Without Entrapment Protection in two channel
configuration the wall control will function as an open/stop device only and in dedicated up/down
configuration the down button will operate as “hold to close” only.
Two Channel Wireless Wall Control
Press and hold the SET button, then whilst holding press STOP 5 times (green status light will light
then continue flashing. Indicating learn mode)
Press the desired WIRELESS ACCESSORY BUTTON to learn door 1 (orange limit light will flash
fast after each wireless accessory is successfully learnt)
Repeat previous step to learn door 2 (if required)
Press STOP to exit learn mode
Dedicated Up/Down Wireless Wall Control
Press and hold the SET button, then whilst holding press STOP 5 times (green status light will light
then continue flashing. Indicating learn mode)
Press the E138G TOP button (the orange LIMIT light will flash at each button press)
Then press the E138G LOWER button
Press the STOP button on the GRIFCO® controller (the green light will continue to flash)
Press the E138G LOWER button again (the green light will go out indicating exit of learn mode)
LEARN THE E840G
WIRELESS KEYPAD FROM
THE CONTROLLER
Press and hold the SET button on the GRIFCO® controller, then
While holding the SET button, press the STOP button 5 times (the green status light will light then
continue flashing, indicating learn mode)
Enter a 4-digit PIN code into the keypad (step 3)
Press the ENTER button (step 4) (orange LED flickers on controller)
To enter additional PIN codes (up to 12) repeat steps 3 & 4
Press STOP to exit learn mode
Install the RADIO LOCK button on the MCB to prevent any further wireless accessories being
learnt, or erased without authority
NOTE: The Grifco® Security + 2.0 Wireless Keypad provides :
Wireless security access
Wireless hold to close
Door 1 Door 2
Top
Button
Lower
Button
Keypad
ENTER
button

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grifco MH Series and is the answer not in the manual?

Grifco MH Series Specifications

General IconGeneral
BrandGrifco
ModelMH Series
CategoryDoor Opening System
LanguageEnglish

Related product manuals